There are many reasons why this situation occurs，Because the customer is installing the conveyor belt，Incorrect installation method，PUSynchronous beltThere is a problem，The entire production line may not be operational。 This situation，The impact is very serious，After purchasing the correct conveyor belt，The installation method is also correct，that，Let's take a look togetherPUSynchronous beltThe correct installation process!

  1、Turn off power，Remove the protective cover，Loosen the assembly bolts of the motor。 After starting the motor，PUSynchronous beltAdequate relaxation，Remove the drive belt without prying it up。 Please do not pry the belt。

  2、When installing the synchronous belt，If the distance between the centers of two pulleys can be moved，To shorten the distance between the centers of the pulleys first，After installing the synchronous belt，Reset distance between centers。

  3、Conveyor manufacturer recommendations，When there is a tensioning pulley，The tensioning pulley should be loosened first，ReinstallationSynchronous belt，Then install the tensioning pulley。

  4、Remove the old belt，Check for abnormal wear，If the transmission device is designed or maintainedThere is a problem，Tie on the pulleySynchronous beltHour，Be careful not to exert too much force，Or pry with a screwdriverSynchronous belt，sendSynchronous belt

  5、When designing the pulley，Choose a structure with two axes that can be close to each other，In situations where structure is not allowed，I hope toPUSynchronous beltInstalled together with the pulley on the corresponding shaft。

  6、When cleaning belts and pulleys，The cloth should be wiped with a little non volatile liquid，It is not advisable to soak or brush the belt with laundry detergent。

  7、To remove oil and stains，Scraping with sandpaper and sharp objects is also clearly not advisable。 The belt should be dry before installation and use。

  PUSynchronous beltEasy maintenance，Low operating costs。 Due toPUSynchronous beltIt's made of glass fiber with low elongation、Made of materials such as steel wire，So the length of the transmission belt is small during operation，No need for a triangle like belt、Regularly adjust the tension of the chain and so on。 in addition，Due toPUSynchronous beltNo lubrication is required during operation，thereforeEasy maintenance，The operating cost is much lower than the triangular belt、chain、gear。

  In the presence of dust、water、Under harsh working conditions of corrosive media，chainEasy to rust、abrasion，The triangular belt will cause sliding，andPUSynchronous beltThe transmission can adapt to these conditions。 Because this is a meshing transmission，thereforeRainwaterofHourI won't slip later。 in addition，waterIt is a good lubricant for rubber，Therefore, it can reduce the size of the beltabrasion。 When there is garbage or foreign matter，Tooth passageSynchronous beltAfter entering the pulley groove，The toothed belt compresses the air that was originally left in the pulley groove，Discharge the compressed air from both sides of the pulley groove。 The compression of this air simultaneously cleans the mating surface、The role of removing garbage and foreign objects，Reduce the number of toothed beltsabrasion。 in addition，Synchronous with high corrosion resistance、Heat resistance，Even in the presence of high temperatures、Able to operate normally even under corrosive gas conditions。

  The above introduction isPUSynchronous beltCorrect installation process，For more information，Feel free to contact us at any time!